This model is designed by enry68 (http://bit.ly/2tUfJJg), thank you very much for your great support. For details, please see the description below:
This is enry68 design that equip the Aycubic Delta/Kossel Mini or Plus with a strip led on the effector.
This design is also compatible with the Original Anycubic Z-Level sensor (v1 or v2)
Thi support is composed of two parts: the support end the refractor.
The support can be printed in any colour, the refractor must be printed with transparent filament.
I have used a 12V LED strip with 3 LEDs, You can tacke the Power for the LED strip from the 12V connector of the Trigorilla mother board. (First connector on the left with the laber "- 5A +" )
Printer: ANYCUBIC i3 Mega
Rafts: Doesn't Matter
Use the supports only for the LED support(not for the refractor), the refractor mu be printed face down without supports and with a transparent filament.