This model is designed by petrzmax (http://bit.ly/2piYtbZ), thank you very much for your great support. For details, please see the description below:
Anycubic I3 Mega bearing holders especially designed for Igus RJ4JP-01-08. These are using M4 Nuts. I have designed these to not squeeze the bearings - They are holding by going into the small stripes inside. Double holder is used on X carriage.
I have added v2 version of Igus double holder and a flat version's (without strips) which I'm using which Igus RJZM-02-08 bearings.
Printer: Anycubic I3 Mega
Resolution: 0.2 mm
Infill: 30% or more